Sapido BR261c User Manual download pdf (Page 82)

A: The wireless system will connect at highest possible speed, depending on

the distance and the environment. To obtain the highest possible connection

speed, you can experiment with following:

◦ Access Point location: Try adjusting the location and orientation of the

Access Point.

◦ Wireless Channel: If interference is the problem, changing to another

channel may show a marked improvement.

◦ Radio Interference: Other devices may be causing interference. You can

experiment by switching other devices off, and see if this helps. Any

“noisy” devices should be shielded or relocated.

◦ RF Shielding: Your environment may tend to block transmission between

the wireless stations. This will mean high access speed is only possible

when close to the Access Point.

• Some applications do not run properly when using the Wireless Router.

A:The Wireless Router processes the data passing through it, so it is not

transparent. Use the Special Application feature to allow the use of Internet

applications which do not function correctly. If this does solve the problem,

you can use the DMZ function. This should work with almost every

application, but:

◦ It is a security risk, since the firewall is disabled.

◦ Only one (1) PC can use this feature.

• I can’t connect to the Wireless Router to configure it.

A:Check the following:

◦ The Wireless Router is properly installed, LAN connections are OK, and it

is powered ON.

◦ Make sure that your PC and the Wireless Router are on the same network

segment.

◦ If your PC is set to “Obtain an IP Address automatically” (DHCP client),

restart it.

◦ If your PC uses a Fixed (Static) IP address, make sure that it is using an IP

Address within the range 192.168.1.129 to 192.168.1.253 and thus

compatible with the Wireless Router’s default IP Address of

192.168.1.254. Also, the Network Mask should be set to 255.255.255.0 to

match the Wireless Router. In Windows, you can check these settings by

using Control Panel ~ Network to check the Properties for the TCP/IP

protocol.

• The WinXP wireless interface couldn’t communicate the WEP with SAPIDO

BR261c’s wireless interface.

A:The default WEP of WinXP is Authentication Open System - WEP, but the

WEP of SAPIDO BR261c is only for Shared Key - WEP, it caused both sides

couldn’t communicate. Please select the WEP of WinXP from Authentication

Open System to Pre-shared Key - WEP, and then the WEP wireless interface

between WinXP and SAPIDO BR261c would be communicated.

1 2 ... 77 78 79 80 81 82 83 84

Comments to this Manuals

No comments

Sapido BR261c User Manual Page 82

Comments to this Manuals

Related products and manuals for Routers Sapido BR261c